VisionFive2 - Hardware Spezifikationen

[FrankM]

Type	Item	Description
Processor:	StarFive JH7110	StarFive JH7110 with RISC-V quad-core CPU with 2 MB L2 cache and a monitor core, supporting RV64GC ISA, working up to 1.5 GHz
	Imagination GPU	IMG BXE-4-32 MC1 with work frequency up to 600 MHz
Memory:	2 GB/4 GB/8 GB	LPDDR4 SDRAM, up to 2,800 Mbps
Storage:	Onboard TF card slot	The VisionFive 2 can boot from a TF card.
	Flash	The firmware to store U-Boot and bootloader.
Multimedia:	Video Output	1 × 2-lane MIPI DSI display port, supporting up to 1080p@30fps
		1 × 4-lane MIPI DSI display port, supporting up to 2K@30fps in both single display and dual display modes.
		1 × HDMI 2.0, supporting up to 4K@30fps or 2K@60fps
		Note: Only one MIPI DSI port can be used for display at a time.
	Camera	1 × 2-lane MIPI CSI camera port, supporting up to 1080p@30fps
	Encoder/Decoder	Video decoder supports up to 4K@60fps and multi-stream for H264/H265;
		Video encoder supports up to 1080p@30fps and multi-stream for H265;
		JPEG encoder/decoder
	Audio	4-pole stereo audio jack
Connectivity:	Ethernet	2 × RJ45 Gigabit Ethernet ports
	USB Host	4 × USB 3.0 ports (multiplexed with a PCIe 2.0 1x lane).
	USB Device	1 × USB device port (by reusing the USB-C port)
	M.2 Connector	M.2 M-Key
	eMMC Socket	For eMMC modules as OS and data storage
	2-Pin Fan Header	-
Power:	USB-C port	5 V DC via USB-C with PD, up to 30 W (minimum 3 A)
	GPIO Power In	5 V DC via GPIO header (minimum 3 A)
	PoE (Power over Ethernet)	PoE function is enabled and requires separate PoE HAT
GPIO:	40-Pin GPIO Header	1 × 40-pin GPIO header, supporting various interface options:
		3.3 V (on 2 pins)
		5 V (on 2 pins)
		Ground (on 8 pins)
		GPIO
		CAN bus
		DMIC
		I2C
		I2S
		PWM
		SPI
		UART
		and so on
Boot Mode:	Boot mode setting pins	You can choose one of the following boot modes:
		1-bit QSPI Nor Flash
		SDIO3.0
		eMMC
		UART
Button:	Reset button	To reset VisionFive 2, press and hold the Reset button for more than 3 seconds to ensure the reset is successful.
Dimensions:	100 × 74 mm	-
Compliance:	RoHS, FCC, CE	-
Environment:	Recommended operating temperature	0-50 ℃
Other:	Debug function	UART TX and UART RX are available through the 40-pin GPIO header.

Quelle: https://doc-en.rvspace.org/VisionFive2/Quick_Start_Guide/VisionFive_2/specification_pb.html

[FrankM]

Schaltdiagramm -> https://doc-en.rvspace.org/VisionFive2/PDF/SCH_RV002_V1.2A_20221216.pdf