Skip to content

VisionFive2 - Hardware Spezifikationen

VisionFive 2
  • Type Item Description
    Processor: StarFive JH7110 StarFive JH7110 with RISC-V quad-core CPU with 2 MB L2 cache and a monitor core, supporting RV64GC ISA, working up to 1.5 GHz
    Imagination GPU IMG BXE-4-32 MC1 with work frequency up to 600 MHz
    Memory: 2 GB/4 GB/8 GB LPDDR4 SDRAM, up to 2,800 Mbps
    Storage: Onboard TF card slot The VisionFive 2 can boot from a TF card.
    Flash The firmware to store U-Boot and bootloader.
    Multimedia: Video Output 1 × 2-lane MIPI DSI display port, supporting up to 1080p@30fps
    1 × 4-lane MIPI DSI display port, supporting up to 2K@30fps in both single display and dual display modes.
    1 × HDMI 2.0, supporting up to 4K@30fps or 2K@60fps
    Note: Only one MIPI DSI port can be used for display at a time.
    Camera 1 × 2-lane MIPI CSI camera port, supporting up to 1080p@30fps
    Encoder/Decoder Video decoder supports up to 4K@60fps and multi-stream for H264/H265;
    Video encoder supports up to 1080p@30fps and multi-stream for H265;
    JPEG encoder/decoder
    Audio 4-pole stereo audio jack
    Connectivity: Ethernet 2 × RJ45 Gigabit Ethernet ports
    USB Host 4 × USB 3.0 ports (multiplexed with a PCIe 2.0 1x lane).
    USB Device 1 × USB device port (by reusing the USB-C port)
    M.2 Connector M.2 M-Key
    eMMC Socket For eMMC modules as OS and data storage
    2-Pin Fan Header -
    Power: USB-C port 5 V DC via USB-C with PD, up to 30 W (minimum 3 A)
    GPIO Power In 5 V DC via GPIO header (minimum 3 A)
    PoE (Power over Ethernet) PoE function is enabled and requires separate PoE HAT
    GPIO: 40-Pin GPIO Header 1 × 40-pin GPIO header, supporting various interface options:
    3.3 V (on 2 pins)
    5 V (on 2 pins)
    Ground (on 8 pins)
    GPIO
    CAN bus
    DMIC
    I2C
    I2S
    PWM
    SPI
    UART
    and so on
    Boot Mode: Boot mode setting pins You can choose one of the following boot modes:
    1-bit QSPI Nor Flash
    SDIO3.0
    eMMC
    UART
    Button: Reset button To reset VisionFive 2, press and hold the Reset button for more than 3 seconds to ensure the reset is successful.
    Dimensions: 100 × 74 mm -
    Compliance: RoHS, FCC, CE -
    Environment: Recommended operating temperature 0-50 ℃
    Other: Debug function UART TX and UART RX are available through the 40-pin GPIO header.

    Quelle: https://doc-en.rvspace.org/VisionFive2/Quick_Start_Guide/VisionFive_2/specification_pb.html